Participation in the CCIL Certification Programs requires that each laboratory implement a quality system that involves an internal audit program.
A series of checklists are provided to assist in the auditing of test procedures.

  • LS200 Penetration of Bituminous Materials
  • LS261 Preparation of Marshall Specimens
  • LS262 Bulk Relative Density of Bituminous Materials
  • LS263 Resistance to Plastic Flow of Bituminous Mixtures
  • LS264 Theoretical Maximum Relative Density of Bituminous Mixtures
  • LS265 Percent Air Voids in Compacted Dense Bituminous Pavement Mixtures
  • LS266 Determination of V.M.A. in Compacted Bituminous Materials
  • LS281 Determination of Percent Compaction of Compacted Bituminous Paving Mixture (BRD Method)
  • LS282 Quantitative Extraction of Asphalt Cement and Analysis of Extracted Aggregates
  • LS284 Recovery of Asphalt Cement from Solution by Abson or Rotovapor
  • LS287 Determination of Percent Compaction of Compacted Bituminous Paving Mixture (MRD Method)
  • LS292 Asphalt Cement Content by Ignition & Analysis of Remaining Aggregate from Bituminous Pavement Mixtures
  • LS306 Bulk Relative Density of Compacted Bituminous Mixtures Using Paraffin Coated Specimens
  • LS310 Determination of Drain Down Characteristics in Uncompacted Asphalt Mixtures
  • LS600 Dry Preparation of Aggregates/Reducing Field Samples
  • LS601 Materials Finer than 75?m Sieve in Mineral Aggregates by Washing
  • LS604 Relative Density of Coarse Aggregate
  • LS605 Relative Density of Fine Aggregate
  • LS607 Percent Crushed Particles in Coarse Aggregate
  • LS608 Percent Flat and Elongated Particles in Coarse Aggregate
  • R28 Accelerated Aging of Asphalt Binder Using Pressure Aging Vessel (PAV)
  • R30 Mixture Conditioning of Hot-Mix Asphalt (HMA)
  • T176 Plastic Fines in Graded Aggregates and Soils by use of the Sand Equivalent Test
  • T240 Effect of Heat and Air on a Moving Film of Asphalt (RTFOT)
  • T283 Resistance of Compacted Asphalt Mixtures to Moisture-Induced Damage
  • T304 Uncompacted Void Content of Fine Aggregate
  • T312 Preparing and Determining the Density of Hot-Mix Asphalt (HMA) Specimens by Means of the Superpave Gyratory Compactor
  • T313 Flexural Creep Stiffness of Asphalt Binder Using the Bending Beam Rheometer (BBR)
  • T315 Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (DSR)
  • T316 Viscosity Determination of Asphalt Binder using Rotational Viscometer (RV)
  • ASTM D6307 Asphalt Content of Hot-Mix Asphalt by Ignition Method
  • ASTM D6752/6752M Bulk Specific Gravity and Density of Compacted Bituminous Mixtures Using Automatic Vacuum Sealing Method